Secures the front lower ball joint and prevents it from backing out. Sold individually. Driver's or passenger's side fitment. 2 necessary per car.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
If your outer tie rods are worn, you will experience sloppy steering response and knocking / creaking sounds. Your outer tie rods keep the steering centered, so failure can be dangerous and can seriously affect steering control. After replacing the tie rods, you will experience tighter, more precise feedback without noise. Tie rod end consists of: 1 qty. Ball joint end 1 qty. Dust bellows / boot 1 qty. Hexagon lock nut 1 qty. Lock nut washer 1 qty. Pin high-quality OEM (original equipment manufacturer) replacement, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. We recommend replacing the right and left side tie rod ends at the same time....(choose a part on the right to read more)
This ring sits between the right and left side heat exchangers on the crossover pipe. We recommend replacing your exhaust gaskets and seals each time you remove your exhaust. If you reuse an old gasket or seal, odds are it will leak and create noise or fill the cabin with noxious fumes. Sold individually. 1 necessary per car.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
Brand new balljoint. Easily installed after drilling out the original factory rivets and replacing them with our special 7mm bolts washers and nuts (ordered separately). If the strut moves against the control arm the balljoint is bad. Will not fit the 85.2 and up 944s and 968 models as that balljoint is built into the control arm.
The symptoms of a worn tie rod end include, clunking, rattling and squeaking when turning, poor alignment and premature tire wear. Have the rod ends inspected when servicing your suspension and proactively change them when noticing any of the symptoms. Genuine part sourced from Porsche ag in Germany to ensure quality, reliability and precise fitment. Sold individually. Left or right-side fitment. 2 necessary per car.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
The shifter or angular joints center plastic bushing wears out with time and can cause the complete loss of all gear selection. This little part can leave you stranded! If you are adding a short shift kit, that is the perfect time to replace it. It is secured to the gear shift levers guide tube and bearing plate. Sold individually. 1 necessary per car.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.