PORSCHE 986 PULLEYSCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1974-77 - Transmission (includes uncategorized and accessory items) 90110556100EQ This is an OEM part, sourced directly from Germany. Sold individually. Left or right side fitment.
$3.30
Make a selection
From $45.32
Make a selection 99919100210 Long blade flat head, for 356c & 911 tool kit, red wooden handle.
$65.00
Make a selection FVD721T44 Pulley wrench. Needed for securing the generator from rotating during r&r of pulley or fan belt. Applicable: model - 911, year 1965-1974.
$49.50
Make a selection
$12.65
Make a selection
$51.43
Make a selection
$12.47
Make a selection FVD2857RSR3 These pulleys have been factory installed (1975 to 1967) in the race cars: Carrera 6, 911 r, 911 st, 2.8 rsr, 3.0 rsr, 914-6 GT. - lower the belt position - prevents skipping the belt - factory v-belts can be used
$267.30
Make a selection
$38.23
Make a selection STP240 This dial gauge holder is needed to properly measure crank shaft flywheel and pulley end-play. Can also be universally to check clearances and run-out. Applicable: most every Porsche and vw air-cooled engine. Please call our office for availability. General Fitment356 1950-59912 1965-69 914 1970-76 911 1965-69 911 1994-98 911 1989-94 911 1987-89 911 1984-86 911 1978-83 930 1975-77 911 1974-77 911 1970-73
$125.55
Make a selection FVD721T34C Oil seal arbor tool necessary for the installation of the oil seal on the pulley side of the crank shaft.
$93.50
Make a selection 2699 The wrench is flat and wide and was designed to hold a tensioner pulley in place while the retaining nut is applied. The retaining-nut usually over hangs its base therefore the wrench has to be flat. No conventionally sold metric key-wrench will clear the base for the retaining-nut installation. Do not look for something else. It was tried before you. It just will not clear. Two types of tensioner pulleys are used in 924-944 today. The metal tensioner pulley and the plastic tentioner pulley.
$43.99
Make a selection 99919217350EQ A severely worn a/c belt will no longer be able to grip the pulleys and will start to slip and cause a loud squealing noise when the a/c is turned on. Belts undergo a lot of friction and wear. They are cost effective to change and will keep you're a/c functioning properly. Be sure to follow recommended service and replacement intervals set by Porsche on belts. High-quality OEM Bosch replacement belt, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. Sold individually. 1 necessary per car.
$18.70
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |