Vehicles
Sections
328 not categorized PORSCHE CAYENNE S EMOCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1978-83 (includes uncategorized and accessory items) 846R9001R01 Material: tig welded, type 304, stainless steel. Finish: satin finish stainless. Weight: 6oz. Models: 996/997, Boxster, 911 & 944. Installation: secures snap-in lap belts to factory tunnel side (inside) seat belt mounting point. Miscellaneous: allows user to remove and install belts in seconds. Will not interfere with factory seat belt. One pair will work for both seats. Note: part# 846 r9002 hardware kit is required for installation in (1985 - 1989) model Porsches. Use part 846 r9003 for outside belt mount.
$69.30
Make a selection 1923 Sway-a-way Porsche 914 front torsion bars are a high-performance direct replacement for your stock bars, available in a wide range of diameters to allow you to choose the right spring rate for your application. As with all our bars, the sway-a-way Porsche torsion bars are made with heat-treated aircraft grade alloy steel and centerless ground for vastly improved durability and consistent spring rate. The stock diameter for these cars is 17.9 mm.
$315.00
Make a selection 115900944020CS Double spring suspension (racing) for 924 only for 20mm spring strut mounting this sport suspension was tuned and tested for racing use only (hockenheimring.net). Perfect handling, recommended for race and clubsport. Not for street use (racing suspension). The lowering is adjustable (30-70mm front and 30-60mm rear). By using springs at the rear axle instead of torsion bars you improve extreme the handling of your car. By removing the rear torsion bars is the weight saving approximately 25kg.
$2,633.40
Make a selection 1034 Ngk traditional plugs are constructed for longer life and optimum performance. Corrugated ribs prevent flashover. Ngk uses only the purest alumina silicate in its ceramic insulator which give all ngk plugs greater strength and better heat transfer. Copper cored and triple sealed to further aid in heat removal and prevent interior leakage. Technical specifications - 14 mm thread, 19 mm (3/4") reach, 13/16" (20.6 mm) hex size, gasket seat, non-resistor, removable terminal, jis height, projected tip, .035" (0.9 mm) gap. General Fitment911 1978-83911 1974-77
$2.85
Make a selection 021115351A Original German oil filter for all 914 and 912e models make sure that you remove and clean the strainer at the same time and replace the strainer gaskets View/Change Diagram
From $9.99
Make a selection TL914FI Handy tool to remove the pins from your fuel injection connectors
$9.95
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |