429 not categorized PORSCHE 964 PANAMERA SCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1989-94 - Pedal System/Levers (includes uncategorized and accessory items) FVD20703500 This oil cooler kit is a must for engines that are modified. It reduces oil temperature and protects the engine. This kit can lower operating oil temperature up to 60* f. Simple installation without cutting or modifying. High quality behr cooler ensures reliability without sacrificing a/c performance as kit is mounted clear of the front a/c condenser. Can be mounted on cars with or without air conditioning. Sold as a complete kit, ready for installation.
$2,981.74
Make a selection FVD205964001VA
$473.00
Make a selection FVD111046 Is your exhaust tip a little old and unappealing to look at? Update it with a more aggressive look. Made from t304 stainless steel with a polished finish. 4 round to fill in the entire bumper cut out. Angle cut to complement the rear bumper. Sold individually. 1 necessary per car.
$162.80
Make a selection
$137.50
Make a selection
$80.30
Make a selection
$4.50
Make a selection
$660.00
Make a selection
$13.15
Make a selection SIC10590151 12 required per engine replaces 90110590151
$25.15
Make a selection
$1,320.00
Make a selection
$284.78
Make a selection FVD205964002VA
$449.90
Make a selection FVD33396410 A cost effective FVD exclusive combination of bilstein clubsport shocks with a set of eibach pro kit springs. This suspension kit is meant for those who want the car to sit at the lowest possible ride height. This set up will allow you to lower the front axle by 2.4 inches (60 mm). This is a perfect kit for clubsport or race use where the surfaces are smooth and even. The stock rs ride height was 1.6 inches (40 mm) lower. So, this is a full 3/4 of an inch (20 mm) lower on the front axle. Sold as a complete kit. 1 kit is necessary per car. Please note: we recommend the b6 / ohlins suspension kits for those looking for more comfort for street use.
$2,726.50
Make a selection FVD333505007
$50.69
Make a selection FVD33396401 A cost-effective combination of bilstein b6 shocks with a set of German h&r lowering springs. This kit is a perfect balance of performance and comfort for street use. Benefits: optimum adhesion and enhanced stability for daily driving and extreme driving situations. Slightly lower stance at 1.3 inches (35 mm) front / 1.18 inches (30 mm) rear. Marked improvement in safety and sportiness. Bilstein gas pressure technology. Bilstein mono-tube/upside-down technology. Made in Germany. Please note: if you would like to reduce the ride height, please order part # 115110016 which will lower the stance by another 1.5 inches (40mm).
$2,538.69
Make a selection FVD551964001 Floor board lightweight (0,59kg / 1,3 lbs) red General Fitment911 1994-98911 1989-94
$125.75
Make a selection FVD33150010 Our weather sealed monoball cartridges are crafted in high carbon steel and 7075 t6 aircraft aluminum. They will positively locate the suspension arms so suspension motion is accurately repeated in every corner. Sold as a set. 1 kit is necessary per car. Please note: we recommend this kit for race use, as noise may resonate inside the cabin during street use. For those that are concerned about the noise, please order part # FVD3310212291
$704.00
Make a selection FVD3522945964R
$3,755.40
Make a selection FVD34350501 Worn bump stops and bellows can cause premature shock damage. We recommend replacing the stops and bellows with any new shock install. This set includes 2 qty. Front bump stops 96434330100 and 2 qty. Front bellows 96434350500 sold individually. 1 necessary per car.
$104.42
Make a selection FVD3419991 This is a cost effective alternative to buying new control arms. Replace worn-out original soft rubber (65 shore hardness value) control arm bushings with new bushings of the same rubber (65 shore hardness value). This bushing set is made in Germany, weather sealed, crafted in high carbon steel and 7075 t6 aircraft aluminum and includes a 65 shore hardness value cores. This is a front and rear bushing for the front lower control arm (wishbone). 2 sets are necessary per car.
$124.30
Make a selection FVD33150030 This kit is complete and includes a total of 8, 4 smaller and 4 larger for the rear control arms. Our weather sealed monoball cartridges are crafted in high carbon steel and 7075 t6 aircraft aluminum. They will positively locate the suspension arms so suspension motion is accurately repeated in every corner. Sold as a set of 8. 1 kit is necessary per car. Please note: noise may resonate inside the cabin during street use.
$746.90
Make a selection FVD545964000 This rear window is a high-quality lightweight replacement that is designed to perform like the original. It is a replacement for original number, 964 545 107 04. Features: 10 % lighter than original (weighs approx. 6 kg (13.2 lbs)) uses the original seal, part # 96454522500 clean appearance - does not include a cut out rear windshield wiper does not include a rear window defroster grid (less wiring / weight) green tinted, curved design like the original made in Germany please note: be sure to check the model fitment tab to ensure this works on your car.
$744.70
Make a selection FVD211343 Already replaced your heater blower tube with a carbon bypass? This carbon / kevlar air duct will match the engine decor perfectly. It is a replica of the factory rs lightweight factory air duct. This is a quality tuning product manufactured by dansk. They offer a complete line of tuning and performance parts to complement the entire Porsche model range. All dansk products are manufactured to the highest of European standards to ensure the quality and performance you expect for your Porsche. This commitment has made dansk one of the original equipment manufacturers (oem) to Porsche in Germany. This installs easily and really dresses up the engine. Sold individually. 1 necessary per car.
$267.30
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |