PORSCHE 964 PORSCHE PARTSCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1994-98 - Transmission (includes uncategorized and accessory items) 911561023606EQ This is a complete cabrio top cover made in Germany with original material. It is as close to the original as possible and is cut and trimmed to fit perfectly. Includes all of the original tenax snaps / retainers in the original locations. This would replace original part # 911 561 023 60 6ha made in Germany. Sold individually. 1 necessary per car.
$1,321.10
Make a selection FVD33396401 A cost-effective combination of bilstein b6 shocks with a set of German h&r lowering springs. This kit is a perfect balance of performance and comfort for street use. Benefits: optimum adhesion and enhanced stability for daily driving and extreme driving situations. Slightly lower stance at 1.3 inches (35 mm) front / 1.18 inches (30 mm) rear. Marked improvement in safety and sportiness. Bilstein gas pressure technology. Bilstein mono-tube/upside-down technology. Made in Germany. Please note: if you would like to reduce the ride height, please order part # 115110016 which will lower the stance by another 1.5 inches (40mm).
$2,538.69
Make a selection 95011614305 A must for replacing your pressure plate, don't overlook adding a new one. High-quality OEM replacement, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. Sold individually. 1 necessary per car.
From $151.59
Make a selection 95011623712EQ When the clutch pedal is depressed, the hydraulic pressure from the master cylinder engages a piston in the slave cylinder to actuate the clutch fork to release your clutch. If the slave cylinder develops a leak or fails, you will not be able to engage or disengage the clutch to shift gears. Sold individually. 1 necessary per car. We also recommend installing our stainless clutch hose, part # FVD42347700
$126.50
Make a selection 146096479 Thermo-tec snap straps General FitmentALL
$29.00
Make a selection 24135296401RS Highlights: made for up to 750*c (1,382*f) for street, some track use and rally use. Low dust, high performance street pad with 20-25% % brake improvement. Capable of repeated heavy brake use without brake "fall-off". Very minimal disc/rotor damage characteristics. Features red "brake in' surface coating for instant safe braking after install. Superb material for European cars. Ece r 90 type approved for most cars. High performance lowest dust rating pads for prestige imports and faster street driving. Redstuff reduce dust by 60-90%. Plus the minimal dust you see is very easily removed with a simple sponge wash as it contains no steel fibre particles as in all other pads. Second they brake like an alligator...(choose a part on the right to read more)
$237.60
Make a selection 100555216C2BR Is your shift boot looking a bit worn and tattered? Replace it with one that is uses high quality materials that we have made in Germany. These boots are well crafted to last as long as the originals. Does not include a knob. Please note: other colors are available upon request. Please indicate the year, model and color code, or give us an ral or pantone color code to go by. Inquire via our website or with an FVD parts specialist.
$317.90
Make a selection 22011090102ATK Sport throttle bodies are a great addition for those with highly modified cars. They are a great addition for those with full exhaust systems (larger diameters), maf kits, larger displacements, street or race cams, etc. The remanufacturing process includes full inspection of your throttle body to ensure proper operation after the remanufacturing process. We then disassemble and bore the original to a 2.7-inch (70.5 mm) diameter. The entire throttle body is cleaned, degreased and the internals are polished to create more laminar flow. We then machine the shaft to accept larger butterfly's which seamlessly match the bore. All clearances are checked for precision to ensure reliability. Each throttle body is reman...(choose a part on the right to read more)
$589.60
Make a selection FVD1169052 Our FVD exclusive line of clutch kits is culmination of Porsche genuine parts, zf sachs race engineering gmbh parts and motorsports parts that have been developed to work together without compromise. They offer a silky smooth release, superb drivability, can handle more torque (350 ft/lbs. / 475 nm max.) than comparable stage 1 type recommendations. We specifically chose a clutch disc with torsion springs that function as a vibration damper between engine and gearbox, in order to give you an effortless release in 1st gear. The disc also contains sintered metal plates that have a higher friction coefficient than plates with organic friction. A sintered disc allows for higher transmittable torque and is more dirt...(choose a part on the right to read more) General Fitment911 1994-98911 1989-94
From $2,322.61
Make a selection 115384 If you are looking for added damping performance on the street, the bilstein b6 performance damper is the ideal solution. The product benefits at a glance: optimum adhesion and enhanced stability for daily driving and extreme driving situations. Marked improvement in safety and sportiness without additional spring changes. Increased service life. Bilstein gas pressure technology. Bilstein mono-tube/upside-down technology. Made in Germany. Road-tested and fine-tuned by bilstein. German TUV registration is not required. Sold individually. 1 necessary per car. We recommend adding our lowering spring collars if you would like a lower ride height, our part # 115110016
$640.20
Make a selection 96410440180 Motorsports item. Sold individually. All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$22.00
Make a selection 9115550551570EQ Quality replacement headliner for original number, 911 555 055 157 00. This is made by dansk, they offer a complete line of replacement parts to complement the entire Porsche model range. All dansk products are manufactured to the highest of European standards to ensure the quality, factory fitment and performance you expect for your Porsche. This commitment has made dansk one of the original equipment suppliers to the Porsche in Germany. Sold individually. 1 necessary per car.
From $192.50
Make a selection 91461354102 Easily installed on the side of the transaxle test by removal and insertion of a small pick. if the reverse lights operate (make sure the key is turned on) then the reverse light pin is worn. View/Change Diagram
From $49.00
Make a selection 90151107321 This is the rear release cable for the rear engine deck lid. It is 1900 mm in length. When replacing this cable, we also recommend replacing the handle, part # 90155281320 and the grommet, part # 91151253100. Also, check your rear lid lower lock, part # 90151205200, perfect time to replace it if it is corroded and the spring is worn. Sold individually. 1 necessary per car.
From $9.50
Make a selection 96410090200EQ FVD cylinder head gasket sets contain high quality German sourced gaskets, seals and o-rings. This kit contains a complete set of gaskets to make a teardown / rebuild more convenient. Sold as a complete set. 1 necessary per car. To complete the gasket set for the whole engine please order part # 93010090104eq
$387.20
Make a selection 444552985051 This is a carbon overlay, meant to be adhered to your original plastic instrument trim. We recommend adhering the carbon overlay to your original with wurth bond and seal (sold separately). Great detail is taken to attempt to match the original weave size, color and polish. Whether you are adding carbon to the interior or matching existing pieces, this is high quality and is made in Germany so it is made to last, like the original. This cover is a carbon overlay to be adhered to the original black plastic piece, part # 911 552 550 00 700 for reference. Sold individually.
$640.20
Make a selection 911561023602EQ This is a complete cabrio top cover made in Germany with original material. It is as close to the original as possible and is cut and trimmed to fit perfectly. Includes all of the original tenax snaps / retainers in the original locations. This would replace original part # 911 561 023 603 av made in Germany. Sold individually. 1 necessary per car. Please note: if you have a 1978-85 model please see our part # 911561023003eq
$1,237.50
Make a selection 96434101707AT By ordering this article number, you will receive a reconditioned wishbone with newly pressed-in bearings. The calculated replacement deposit will be returned to you as soon as the old part has been received and checked. This item is also available with race bearings (85 shore).article number FVD 341 017 07at the reconditioning process includes full inspection of each track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we properly install our OEM front control arm bushings, part # FVD3419991. They are made with 65 shore rubber like the original control arms. If your old part is not repairable we will inform y...(choose a part on the right to read more)
$418.00
Make a selection 96434101807AT By ordering this article number, you will receive a reconditioned wishbone with newly pressed-in bearings. The calculated replacement deposit will be returned to you as soon as the old part has been received and checked. This item is also available with race bearings (85 shore).article number FVD 341 018 07at the reconditioning process includes full inspection of each track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we properly install our OEM front control arm bushings, part # FVD3419991. They are made with 65 shore rubber like the original control arms. If your old part is not repairable we will inform y...(choose a part on the right to read more)
$418.00
Make a selection 964347009BXATK This steering rack is a remanufactured part with a core, as such an additional charge (a core deposit) will be added to the purchase price of the part. After receiving your new part, kindly send back your old part, or core . Once the core is returned to us and it has been inspected to ensure it is rebuild-able and resell-able, the core deposit will be refunded. The remanufacturing process includes full inspection and testing for structural integrity. We then disassemble and bead blast to remove corrosion. Internals are micro-finished to OEM specifications. Sealing surfaces are carefully checked and restored prior to installing new premium seals and o-rings. Each unit is then carefully tested for full functional...(choose a part on the right to read more)
$1,633.50
Make a selection 964541225001 This genuine Porsche windshield seal is an integral part of keeping your cowl from rusting. It is critical that the gasket and windshield are properly installed to prevent corrosion. Sold individually. 1 needed per car. Please note: for the 911 models, this does not contain the trim frame slot for chrome / black trim like the earlier cars.
$406.00
Make a selection 96457278500EQ This part is sourced in Germany to ensure quality, reliability and precise fitment. Sold individually. 2 necessary per car.
$79.20
Make a selection 96455583200VEQ Attention to detail is what distinguishes our parts from the competition. We source these door pulls in Germany to ensure that the material and stitching are made as closely to the originals as possible. This is a shade similar to the original speed yellow. Sold individually.
$38.79
Make a selection 99336105700EQ Genuine quality wheel nut and lock set in black. The set includes a key. Please check the exact model designation for this part below. Sold as a set. 1 set necessary per car.
$106.70
Make a selection 96550340201EQ Quality replacement part for original number, 965 503 402 01 grv. This is made by dansk, they offer a complete line of replacement bodywork to complement the entire Porsche model range. All dansk products are manufactured to the highest of European standards to ensure the quality, factory fitment and performance you expect for your Porsche. This commitment has made dansk one of the original equipment suppliers to the Porsche in Germany. Sold individually. Passenger's side fitment.
$213.40
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |