Vehicles
Sections
368 not categorized PORSCHE 964 GERMANCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1994-98 (includes uncategorized and accessory items) 91163510221 As our classics age their horns tend to change pitch or stop working completely. Inspect yours to ensure that they are working properly. Sold individually. 1 necessary per car. View/Change Diagram
From $69.00
Make a selection 91156419300 This is the felt or velvet sealing strip that protects the outer edge of the sunroof panel. It assists in keeping out moisture and protects the panel during operation. It can become brittle and will crack overtime so it is essential that it is in good order. It can also lose the plush black appearance with wax applications. Sold individually. 1 needed per car. View/Change Diagram
From $22.00
Make a selection 93010314781SET Oem parts, sourced directly from Germany. Sold individually. 1 necessary per car.
$366.30
Make a selection 92830421010
$165.00
Make a selection 93010090104EQ High-quality victor reinz replacement gaskets, o-rings and washers to reseal your engine case (short block). Victor reinz has been supplying German auto manufacturers and Porsche for decades. They are a trusted name in gaskets and sealing products. This kit is complete with everything needed and we source this directly in Germany for an added level of quality. Sold individually. 1 set necessary per car. Please note: if you prefer the genuine crankshaft sealing ring, please order part # 99911342641 this also includes the intermediate shaft o-ring, part # 99970731540. Please check the model fitment tab to ensure accurate fitment.
$118.80
Make a selection 96434123770 Sold individually. All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$443.30
Make a selection 96433106080 Our spring plates are manufactured in europe by an OEM supplier to Porsche using the finest materials (high carbon steel, 7075 t6 aluminum and 65 shore rubber - oe spec). Sold individually. Right side fitment. 1 qty. Required.
$680.00
Make a selection 96430091200 Specifically fits the g50.03 / 04 / 05 and g50.10 / 52 sold individually. Please note: please see the specific models that this seal fits listed below. View/Change Diagram
From $108.00
Make a selection 96433105980 Our spring plates are manufactured in europe by an OEM supplier to Porsche using the finest materials (high carbon steel, 7075 t6 aluminum and 65 shore rubber - oe spec). Sold individually. Left side fitment. 1 qty. Required.
$680.00
Make a selection 96410507900 Sold individually. 1 necessary per car. View/Change Diagram
From $160.60
Make a selection 96410508000 Sold individually. 1 necessary per car. View/Change Diagram
From $160.60
Make a selection 96411124701EQ This sealing ring seals the mufflers and exhaust tip / tips. Sold individually.
$23.10
Make a selection 115900964BIVAU1 Looking to lower the ride height on your pss9 suspension further without sacrificing ride quality? Our kit is just the trick, it allows you to lower a full 1.5 inches (40mm) beyond the lowest pss9 setting, simply by replacing the spring plates. Our kit does not change the damping and spring characteristics even though the car has been lowered further. Sold as a kit for the 2 front axle shocks. General Fitment911 1994-98911 1989-94
From $383.90
Make a selection 1159029964WD The ohlins road & track suspension gives our customers a true racing experience, with their own cars, without losing comfort when commuting to work. Our unique dual flow valve (dfv) technology allows you to quickly change the stiffness of the shock absorber. When arriving to the racetrack, just turn the golden knob clockwise on the damper to set it in race mode this action changes all four areas in the damper; low and high speed compression and rebound damping. With ohlins road & track coil overs you will experience a car with blistering response times, improved bump absorption and a massive amount of grip to increase the safety when driving your car on the limit. The car will be easier to balance on the edge o...(choose a part on the right to read more)
$5,635.30
Make a selection 115385 If you are looking for added damping performance on the street, the bilstein b6 performance damper is the ideal solution. The product benefits at a glance: optimum adhesion and enhanced stability for daily driving and extreme driving situations. Marked improvement in safety and sportiness without additional spring changes. Increased service life. Bilstein gas pressure technology. Bilstein mono-tube/upside-down technology. Made in Germany. Road-tested and fine-tuned by bilstein. German TUV registration is not required. Sold individually. 1 necessary per car. We recommend adding our lowering spring collars if you would like a lower ride height, our part # 115110016
$640.20
Make a selection 96411601463 Made in Germany by sachs to original specifications. Direct replacement for the oe clutch disc. 240 mm with a rigid center. 2.4 lbs (1.10 kg) View/Change Diagram
From $191.52
Make a selection 96414718703EQ Remove the power steering belt cover to inspect your toothed steering belt for wear and cracking. Belts undergo a lot of friction and wear, so replacing them periodically will prevent damage. Be sure to follow recommended service and replacement intervals set by Porsche on belts or examine the power steering pump belt at each oil change. Sold individually. 1 necessary per car.
$68.20
Make a selection 96410503000 Are you replacing your timing chain? If so, we also recommend replacing all chain timing rails. For reference the timing chain is, part # 99310552900. Sold individually. 1 necessary per car. View/Change Diagram
From $45.10
Make a selection 964555251000EQ Attention to detail is what distinguishes our parts from the competition. We source these door handles in Germany to ensure that they are made as closely to the original as possible. Sold individually.
$95.46
Make a selection 96453109600EQ This is a genuine door seal that seals the entire door and window frame. As these classics age the original gasket can become brittle and will crack, so it is essential that it is in good order as it keeps moisture out of the cabin. Sold individually. 1 necessary per car.
$215.60
Make a selection 96437502301RATK Send us your OEM transmission mount bracket and we will restore it to better than new condition! Our service includes removal of the old mount, media blasting, proper installation of the new mount and protective seal coating. Our transmission mount is manufactured in europe by an OEM supplier using the finest materials (high carbon steel, 7075 t6 aluminum and 85 shore rubber - rs spec). Simply order and send us your OEM bracket, we will take care of the rest. Approximate lead time is estimated between 3-6 weeks.
$176.00
Make a selection 96453705700SET If you are hearing a crunching or creaking noise when you close your door, start by replacing your door check / door arrester. It prevents the door from opening to widely or slamming. As our cars age, they wear out and start to become very noisy. We also recommend replacing the door check bolt, and safety clip, so we have created an complete set for one door - repair sold individually. Left of right side fitment. 2 needed per car.
$64.13
Make a selection 96434307181ATK Looking for a more cost-effective solution than ordering a new link? Let us recondition your original drop link. The reconditioning process includes full inspection, disassembly, degreasing and media blasting. Once fully prepared, we properly install new bushings, finish with a corrosion proof coating and include a new lock nut. Please note: each link is remanufactured in Germany, so the lead times can vary. If we cannot remanufacture your link we will notify you as soon as we can. Arrangements can be made for its return to you. Sold individually. 1 necessary per car.
$194.70
Make a selection 96437502301ATK Send us your OEM transmission mount bracket and we will restore it to better than new condition! Our service includes removal of the old mount, media blasting, proper installation of the new mount and protective seal coating. Our mount is remanufactured in europe by an OEM supplier using the finest materials. It is a 65 shore rubber hardness value which is the same as the what was standard on these cars. Simply order and send us your OEM bracket, we will take care of the rest. Approximate lead time is estimated between 3-6 weeks.
$178.20
Make a selection 96450501800 This support assists in absorbing impacts and supports the bumper reinforcement bars. Sold individually. 2 necessary per vehicle.
From $103.40
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |