PORSCHE 993 BUSHISCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1998-05 - Engine (includes uncategorized and accessory items) FVD33150005 Restore proper suspension geometry with this adjustable lower rear control arm. The factory control arm cannot compensate enough when lowering your Porsche, leaving you with as much as ½ inch of toe in. The result is poor handling and rapid tire wear. This kit will provide the additional adjustment needed. The adjusting link has a left and right hand thread on each end. Rotating the link will increase or decrease the overall length of the arm. A precision teflon lined spherical rod end replaces the compliant rubber factory bushing for improved suspension response and feedback, and also reduces toe changes during acceleration and deceleration. Sold in pairs. 1 necessary per car.
$764.50
Make a selection ST1089 This pilot bearing puller was designed to easily extract bearings and bushings with an id of 15 mm and up to 20 mm. For bearing use only; not for bushings. Please call our office for availability. General FitmentALL
$79.95
Make a selection
$21.85
Make a selection 92880390400 Replace your worn or warped alternator pulleys before they destroy the alternator shaft bushings. Worn nuts and pulleys may also cause belt loss leaving you stranded.
$31.45
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |