PORSCHE 964 PORSCHE PARTSCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 912 1965-69 - Front Axle/Steering (includes uncategorized and accessory items) 93010090104EQ High-quality victor reinz replacement gaskets, o-rings and washers to reseal your engine case (short block). Victor reinz has been supplying German auto manufacturers and Porsche for decades. They are a trusted name in gaskets and sealing products. This kit is complete with everything needed and we source this directly in Germany for an added level of quality. Sold individually. 1 set necessary per car. Please note: if you prefer the genuine crankshaft sealing ring, please order part # 99911342641 this also includes the intermediate shaft o-ring, part # 99970731540. Please check the model fitment tab to ensure accurate fitment.
$118.80
Make a selection 93060201501 Complete distributor without an exchange. This distributor has been completely remanufactured, which includes a full inspection, disassembly, cleaning and degreasing. We then install a toothed timing belt, 3 German made top bearings, 1 German made lower bearing and a distributor pinion pin (part # 930 602 922 00). We also install new dust caps, Bosch rotors and Bosch cap. Clearances, timing and proper operation are then checked to ensure reliability.
$2,534.48
Make a selection 91155507860700R01 Genuine part sourced in Germany to ensure quality, reliability and precise fitment. Sold individually. 1 necessary per car. Like new
$150.00
Make a selection 993555032700EQ This is an original replacement door panel that is a perfect reproduction made in Germany. Features: period correct material with the correct graining water resistant fiberboard base layer of sound absorption foam perforations are die cut for superior fitment made in Germany sold individually. 1 necessary per car. If you would like a set, the driver's side is part # 993555031700eq
$345.40
Make a selection 9115550551550EQ Quality replacement headliner for original number, 911 555 055 155 00. This is made by dansk, they offer a complete line of replacement parts to complement the entire Porsche model range. All dansk products are manufactured to the highest of European standards to ensure the quality, factory fitment and performance you expect for your Porsche. This commitment has made dansk one of the original equipment suppliers to the Porsche in Germany. Sold individually. 1 necessary per car.
$249.70
Make a selection 930105043021 This is an OEM part, sourced directly from Germany. Sold individually. 12 necessary per car.
$169.40
Make a selection 4440448006005AK High quality polished switch cover. Send us your original cover and we will install the carbon for you. We do not offer a core exchange on this part. Great detail is taken to attempt to match the original weave size, color and polish. Whether you are adding carbon to the interior or matching existing pieces, this is high quality and is made in Germany so it is made to last, like the original. Please note: knob is not included. It is not necessary for you to send us your knob. Sold individually. We also recommend replacing your missing or broken switch cover clips, part # 94455255700. 2 are needed per switch cover. If you would also like to replace the knob, use part # FVD33399603b8
$553.41
Make a selection 44404480060041 High quality polished lower switch cover. This is a carbon overlay, meant to be adhered to your original plastic lower switch cover. Great detail is taken to attempt to match the original weave size, color and polish. Whether you are adding carbon to the interior or matching existing pieces, this is high quality and is made in Germany so it is made to last, like the original. Sold individually. We also recommend replacing your missing or broken switch cover clips, part # 94455255700. 2 are needed per switch cover. If you would also like to replace your knobs, use part # FVD33399603b8
$514.80
Make a selection 44404480062 High quality polished center console set that includes a polished carbon handbrake, the upper switch and lower switch covers made ready for installation. Each piece is a carbon overlay, meant to be adhered to your original plastic trim covers. We recommend adhering the carbon overlays to your originals with würth bond and seal (sold separately).
$1,460.80
Make a selection 911561050002FA1 We go to extra lengths to ensure that our linings are as similar to the originals as possible. Each is cut and trimmed to fit perfectly. Replaces original part # 911 561 050 002 fx made in Germany. Sold individually. 1 necessary per car. Please note: specific model fitment below.
$177.10
Make a selection 91156128300R01 Genuine part sourced from Porsche ag in Germany to ensure quality, reliability and precise fitment. Sold individually. 1 necessary per car. Like new
$34.10
Make a selection 115385 If you are looking for added damping performance on the street, the bilstein b6 performance damper is the ideal solution. The product benefits at a glance: optimum adhesion and enhanced stability for daily driving and extreme driving situations. Marked improvement in safety and sportiness without additional spring changes. Increased service life. Bilstein gas pressure technology. Bilstein mono-tube/upside-down technology. Made in Germany. Road-tested and fine-tuned by bilstein. German TUV registration is not required. Sold individually. 1 necessary per car. We recommend adding our lowering spring collars if you would like a lower ride height, our part # 115110016
$640.20
Make a selection 96410440180 Motorsports item. Sold individually. All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$22.00
Make a selection FVD803993VR0222 High quality, German made three-point replacement safety belt, designed to perform like the original. Features / specs: belt length: 300 cm (118 inches) 3 point inertia reel belt angle adjustable reel (max. Of 8 *) includes 22 cm (8.5 inch) buckle, installation hardware and caps. Din-en-iso 9001: 2000 quality standard manufactured, e-mark approved. The matching rear belt is part # FVD803993hr sold individually. 2 necessary per car.
$187.00
Make a selection 964541225001 This genuine Porsche windshield seal is an integral part of keeping your cowl from rusting. It is critical that the gasket and windshield are properly installed to prevent corrosion. Sold individually. 1 needed per car. Please note: for the 911 models, this does not contain the trim frame slot for chrome / black trim like the earlier cars.
$406.00
Make a selection FVD6314051US Now we can offer you quality clear turn signals. . They will not fade and discolor with time like those on the market in the past. The set includes 2 qty., 12v 21 watt us spec. Amber bulbs to meet road regulations. Sold as a set. 1 necessary per car. Please note: these are euro spec turn signals, so the flat side reflectors hole for the bulb holder is not cutout. Us customers can drill / dremel out the reflector and install their bulb holder and 2 qty. Bulb part # 99963113890 . Looking for a cost effective h4 euro headlight conversion? Check out our part # FVD63191101
$319.73
Make a selection 95011623712EQ When the clutch pedal is depressed, the hydraulic pressure from the master cylinder engages a piston in the slave cylinder to actuate the clutch fork to release your clutch. If the slave cylinder develops a leak or fails, you will not be able to engage or disengage the clutch to shift gears. Sold individually. 1 necessary per car. We also recommend installing our stainless clutch hose, part # FVD42347700
$126.50
Make a selection 964555251001EQ Attention to detail is what distinguishes our parts from the competition. We source these door handles in Germany to ensure that they are made as closely to the original as possible. Sold individually.
$111.84
Make a selection 96434101807AT By ordering this article number, you will receive a reconditioned wishbone with newly pressed-in bearings. The calculated replacement deposit will be returned to you as soon as the old part has been received and checked. This item is also available with race bearings (85 shore).article number FVD 341 018 07at the reconditioning process includes full inspection of each track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we properly install our OEM front control arm bushings, part # FVD3419991. They are made with 65 shore rubber like the original control arms. If your old part is not repairable we will inform y...(choose a part on the right to read more)
$418.00
Make a selection 96434123770 Sold individually. All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$443.30
Make a selection 96420713004EQ This connects to the side of the oil tank. We recommend replacing 2 qty. Clamps, part # 99951235602 when replacing this piece. Sold individually. 1 necessary per car.
$11.00
Make a selection FVD641200965 Quality made in Germany. We recommend installing a new rubber sealing ring, part # 91164190201. Made of acrylic. Includes the cut out for the trip counter. Sold individually. 1 necessary per car.
$44.00
Make a selection 96434101707AT By ordering this article number, you will receive a reconditioned wishbone with newly pressed-in bearings. The calculated replacement deposit will be returned to you as soon as the old part has been received and checked. This item is also available with race bearings (85 shore).article number FVD 341 017 07at the reconditioning process includes full inspection of each track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we properly install our OEM front control arm bushings, part # FVD3419991. They are made with 65 shore rubber like the original control arms. If your old part is not repairable we will inform y...(choose a part on the right to read more)
$418.00
Make a selection KEV53100501 Made in europe by one of the manufacturers to Porsche. Extremely high-quality kevlar / carbon door that includes every detail for a perfect fit. Features: - produced by an OEM manufacturer. - highest quality standards. - perfect fitment. - lightweight 4 kg (8.81 lbs) - kevlar / carbon - mounting is just like factory, no modifications are necessary. ** does not include the inner protection bar please note: these are high quality parts that take time to manufacture and cure properly. Lead times can vary anywhere from 15-30 days depending on where you are in the world. Hinges are not provided; original hinges must be used. Please let us know the year and model and if you intend to use electric windows and electric...(choose a part on the right to read more)
$3,285.70
Make a selection 96550340101EQ Quality replacement part for original number, 965 503 401 01 grv. This is made by dansk, they offer a complete line of replacement bodywork to complement the entire Porsche model range. All dansk products are manufactured to the highest of European standards to ensure the quality, factory fitment and performance you expect for your Porsche. This commitment has made dansk one of the original equipment suppliers to the Porsche in Germany. Sold individually. Driver's side fitment.
$213.40
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |