Cover to keep the hood release handle in its place. located to the left of the driver's left calf, these parts often break as they become brittle and are under greater stress as the years go by. when replacing make sure you lubricate the hood release cable.
Fearures
- high thermal conductivity
- high heat transfer
- contains no petroleum distillates
- use on rubber o-rings, seals, spark plug boots, plastic gears, etc.
- low toxicity
- use when installing bulbs, fuel injection connectors
- waterproof electrical connectors on boats & jet skis, etc.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
At last a bracket to hold the end of the 914 accelerator cable when converting to carburation. Easily installed in the casing, this eliminates fabricating your own.
Replaces worn and defective accelerator pump diaphragm to eliminate hesitation and stumble during acceleration. Fits just like original parts. Manufactured from fuel resistant, rubber membrane with silicon bronze center plunger hardware. Fits weber 32-36 dgv 5a / 32/36 dgev 38mm
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.