Vehicles
Sections
363 not categorized PORSCHE 964 CHECK ON ORDERCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 968 1992-95 (includes uncategorized and accessory items) 96434703200SP We are committed to Porsche cars and are very happy to release an outer tie rod that consists of a monoball joint. Until now this was something that was really only available on racing models. Our tie rod will provide you with unequalled steering precision for street and track use. This component is manufactured in europe and contains the finest materials available, high carbon steel and 7075 t6 aluminum. Installation is seamless, this is a direct replacement for the OEM number, 964 347 032 00. This is ideally suited for use with our monoball inner tie rod, part # 96434705805sp for the 964 c2 / turbo look or 965 or part # 96434705804sp for the 964 c4 or rs. Please note: this is not for the wide body. Sold indiv...(choose a part on the right to read more)
$322.21
Make a selection 96450204200EQ Quality replacement part for original number, 964 502 041 00 grv. This is made by dansk, they offer a complete line of replacement bodywork to complement the entire Porsche model range. All dansk products are manufactured to the highest of European standards to ensure the quality, factory fitment and performance you expect for your Porsche. This commitment has made dansk one of the original equipment suppliers to the Porsche in Germany. The inner mount is adjustable to properly attach / adjust the striker plate. We recommend adding new striker plates and striker plate gaskets, right side striker plate is part # 99353103001 and the gasket is either 90153170323 or 90153170324 depending on what thickness you need....(choose a part on the right to read more)
$107.80
Make a selection 96437504381UNI The rs model engine mount is not a hydro-elastic mount like most models. It contains a rubber core with an 85-shore hardness value. That equates to a more responsive chassis and improved shifting response. A perfect compromise for street and track use as it is more forgiving than aftermarket solid mounts. Sold individually. 2 necessary per car. To install these mounts on any model 964 / 965 / 993 and 993 tt, we recommend our rs engine mount set that includes 2 mounts and all the mounting hardware, part # FVD375964
$218.90
Make a selection FVD375003 Are you experiencing vibrations in the cabin? The most likely cause is a worn transmission mount. Severely worn mounts translate to engine component wear and can even cause difficulty shifting. Our mount is manufactured in europe by an OEM supplier using the finest materials. It is a 65 shore rubber hardness value which is the same as the what was standard on these cars. Be sure to swap yours out during your next service. Sold individually. Central fitment in transmission carrier 96437502301. 1 qty. Required. Tech tip: now is the time to replace the old hardware as well. Below is a list of what is needed for installation. 1 qty. Hex head bolt m10x100 90007429202 1 qty. Lock nut m10 49020001 2 qty. Washers 10.3x...(choose a part on the right to read more)
$165.00
Make a selection 96450113500EQ Quality replacement part for original number, 964 501 135 00 grv. This is made by dansk, they offer a complete line of replacement bodywork to complement the entire Porsche model range. All dansk products are manufactured to the highest of European standards to ensure the quality, factory fitment and performance you expect for your Porsche. This commitment has made dansk one of the original equipment suppliers to the Porsche in Germany. Sold individually. Driver's side fitment. Fits 911 models from 1966-94. Please note: due to variances in production at the factory, age, accident damage or rust, each part may require trimming and or adjustment for perfect fitment.
$133.10
Make a selection 96434705804SP We are committed to Porsche cars and are very happy to release an inner tie rod that consists of a monoball joint. Until now this was something that was really only available on racing models. Our tie rod will provide you with unequalled steering precision for street and track use. This component is manufactured in europe and contains the finest materials available, high carbon steel and 7075 t6 aluminum. Installation is seamless, this is a direct replacement for the OEM number, 964 347 032 00. We also suggest replacing your outer tie rods, part # 96434703200 (qty. 2 are needed) and now is also a good time to replace your worn out inner tie rod dust bellows, part # 96434719103. Please note: this is not for the ...(choose a part on the right to read more)
$196.90
Make a selection 96450520181 Original rsr spoiler flaps fits all 964 narrow body's.
$400.40
Make a selection 96450520281 Original rsr spoiler flaps fits all 964 narrow body's.
$400.40
Make a selection 9645550550070EQ Quality replacement headliner for original number, 964 555 055 007 00. This is made by dansk, they offer a complete line of replacement parts to complement the entire Porsche model range. All dansk products are manufactured to the highest of European standards to ensure the quality, factory fitment and performance you expect for your Porsche. This commitment has made dansk one of the original equipment suppliers to the Porsche in Germany. Sold individually. 1 necessary per car.
$207.90
Make a selection 96450520180 Original rsr spoiler flaps fits all turbo or wide body's. For 964 (narrow body) please order 964 505 201 81.
$401.50
Make a selection 964564201007EQ This is the perforated sunroof lining, it is made in Germany with original material. It is as close to the original as possible and is cut and trimmed to fit perfectly. This part replaces original part # 964 564 201 007 00 sold individually. 1 necessary per car.
$127.60
Make a selection 96410524707ST This fits 964 c2 / c4 and rs models with engine codes # m64.01/02/03. This is an OEM part, sourced directly from Germany. Professional installation is required. Different manufacturing tolerances require an inspection of the free clearance of all parts! If you're not sure about what parts are right for your build, be sure to ask one of our parts specialists. Sold individually. 1 necessary per car.
$1,410.20
Make a selection 99335140887 This was the rotor used on the 964 cup / rsr / 964 cup / rsr / 993 cup / rsr / GT2 evo. This disc is a genuine motorsports replacement part. It is drilled and vented. Sold individually. The corresponding right side is part # 99335140887 all motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$721.60
Make a selection 99357301103 Condensers release heat from the a/c system, by transforming gas into liquid to absorb heat. Condensers can suffer from internal clogging, seams leaking or can be plugged or damaged by road debris. Be sure to replace as needed to keep the hvac system operating perfectly, especially after a compressor failure. When replacing the condenser, we also recommend replacing the auxiliary condenser fan, part # 96462403501 sold individually. 1 necessary per car.
From $223.30
Make a selection 99919234350EQ Belts undergo a lot of friction and wear. They are cost effective to change and will keep your alternator and engine in good condition. Be sure to follow recommended service and replacement intervals set by Porsche on belts. For 964 c2 tip trans. / 993 tip trans. / 993 c2/ s manual trans. And the 993 turbo. Sold individually. 1 necessary per car.
$11.00
Make a selection FVD34101707ATK Unsure about installing replacement bushings and bearings? Send us your control arm and we will properly recondition and install the bushings and bearings for you. The reconditioning process includes full inspection of your track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we will properly install our FVD clubsport front control arm bushings, part # FVD341999r. They are made with 85 shore rubber (like the rennsport model). Please note: each control arm is remanufactured in Germany, so the lead times can vary. If we cannot remanufacture your control arm we will notify you as soon as we can. Arrangements can ...(choose a part on the right to read more)
$418.00
Make a selection FVD11196415GKT This installation kit is needed to install our part numbers FVD 111 964 15 or FVD 111 964 17. Sold as a set. 1 necessary per car.
$42.90
Make a selection FVD3310212291 Our rear trailing arm bushings contain rubber inserts with a shore hardness value of 85, like what is used on rennsport models. It offers rs style handling characteristics, superior durability and is still forgiving enough for street use. - better handling. - makes precision adjustments of the suspension easier. - does not produce road noise. - shore hardness value of 85. - direct OEM replacement. - more forgiving for street use. -includes press tools and grease for easier assembly. Sold as a set. 1 kit is necessary per car. Please note: this fits the 964 c2 / c4 and rs america. Not keen on installing or having the bushings installed at a shop? Please check out our part # FVD33399603b8 and FVD33399603b8, we wil...(choose a part on the right to read more)
$902.00
Make a selection FVD34350501 Worn bump stops and bellows can cause premature shock damage. We recommend replacing the stops and bellows with any new shock install. This set includes 2 qty. Front bump stops 96434330100 and 2 qty. Front bellows 96434350500 sold individually. 1 necessary per car.
$104.42
Make a selection FVD351425426EQ A quality, cost effective set of replacement "big red" style calipers. These are a direct replacement for the 965 turbo, 993 c4s / rs and 993 turbo but can be installed on many 964 / 993 models with the correct caliper adapters. Please contact your FVD parts specialist for fitment questions. We also recommend swapping out your brake lines for a set of stainless braided lines when replacing calipers. Also a now is the time to install a set of our speed bleeders, part # FVD910102. They are comparable to part numbers 993 351 425 10 and 993 351 426 10. Please note: these are aftermarket calipers and do not come with the logo or brake pads. Sold individually. 1 necessary per car.
$874.50
Make a selection FVDBS352965002 Make your next brake service a breeze with our pre-packaged service kits. Quality means everything to us, so we only source these parts directly in Germany. This kit contains: 1 qty. Oem set of rear pads (4 total), part # 96535293904 2 qty. Oem brake warning sensors, part # 96461236502 4 qty. Oem brake pad damping shims (34 mm piston), part # 96535209601 4 qty. Oem brake pad damping shims (30 mm piston), part # 99635208600 please note: this is for the European rs only, not for the rs america. This also fits both the 965 3.3l and 3.6l.
$174.90
Make a selection FVD545964000 This rear window is a high-quality lightweight replacement that is designed to perform like the original. It is a replacement for original number, 964 545 107 04. Features: 10 % lighter than original (weighs approx. 6 kg (13.2 lbs)) uses the original seal, part # 96454522500 clean appearance - does not include a cut out rear windshield wiper does not include a rear window defroster grid (less wiring / weight) green tinted, curved design like the original made in Germany please note: be sure to check the model fitment tab to ensure this works on your car.
$744.70
Make a selection FVD375003S Are you experiencing vibrations in the cabin? The most likely cause is a worn transmission mount. Severely worn mounts translate to engine component wear and can even cause difficulty shifting. We can offer your c4 a more sporty feel without the harsh vibration from a solid mount. Our transmission mount is manufactured in europe by an OEM supplier using the finest materials (high carbon steel, 7075 t6 aluminum and 85 shore rubber - rs spec). The rs spec shore rubber offers the c4 sportier handling without being too stiff for street use. Be sure to swap yours out during the next service. Sold individually. Central fitment into the transmission carrier bracket 96437502301. 1 qty. Required. Tech tip: now is the ti...(choose a part on the right to read more)
$176.00
Make a selection FVD55259200 High quality polished carbon dash trim piece. Great detail is taken to match the original weave size, color and polish. Whether you are adding carbon to the interior or matching existing pieces, this is high quality and is made in Germany so it is made to last, like the original. This cover is a carbon replacement for original # 964 552 232 01 01c. Sold individually.
$81.40
Make a selection FVD55246600 High quality polished carbon dash trim piece. Great detail is taken to attempt to match the original weave size, color and polish. Whether you are adding carbon to the interior or matching existing pieces, this is high quality and is made in Germany so it is made to last, like the original. This cover is a carbon replacement for original # 964 552 466 00 01c. Sold individually.
$133.10
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |