![](https://30ed524141d0cac60ab4-d2e2d18a14257de3b9ce428cf077ee97.ssl.cf2.rackcdn.com/acban.jpg)
PORSCHE 924 GT M OPTIONSCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 968 1992-95 - Brakes/Wheels (includes uncategorized and accessory items) ![]() FVD123019ATK Our k24 sport turbocharger is based off the optional k24 turbochargers, found in the GT2 or 993 turbo x50 models. They are remanufactured by borg warner certified technicians in Germany and are a cost-effective solution. The remanufacturing process includes full inspection of the turbocharger to ensure proper operation after the remanufacturing process. We then disassemble, clean and degrease the unit. The compressor wheels are exchanged, lightened and modified for more air flow. All clearances / shaft tolerances are checked for precision to ensure reliability. The end result is 20-30 additional horsepower, in the low and mid rpm range over the factory turbo. The sport turbo also has less lag than a factory k24...(choose a part on the right to read more)
$2,042.70
Make a selection BES99125020SK No need for Porsche sport exhaust (pse) envy with this muffler! This offers weight savings and a far more exotic sound than the pse, all without drone. It is the perfect compromise for you and your loved ones. Rich, deep, turbo motorsport tones with the valves open and soft subtle, completely stock sounds with them closed. Top of the line or range depending on the english and is the best choice for a daily driver. Features: - + 16 crank hp & + 15 crank torque. - weighs 37 lbs. (17 kg) - German v2a - x5crni18-10 - 1.4301 stainless steel for improved durability. - direct bolt on replacement for the factory center muffler. - includes necessary installation hardware. - reduces turbo lag, backpressure and thermal lo...(choose a part on the right to read more)
$4,651.90
Make a selection BES98115001SK This is our jekyll and hyde version ! The perfect compromise for you and your loved ones. Rich, deep race car tones with the valves open and soft subtle, completely stock sounds with them closed. Top of the line or range depending on the english, and is the best choice for a daily driver. + 11 hp & + 10 tq gain. - thermal insulation on piping to keep suspension components cool. Withstands up to 2,012 degrees fahrenheit (1,100 degrees celsius). - 2 1/2 tubing (63.5 mm). - 2 x 3.5 (90 mm) round tips. - intoxicating growl at idle, partial throttle and wide open throttle. - German v2a - x5crni18-10 - 1.4301 stainless steel for improved durability. - minimal resonance / drone in the cabin (200 rpms worth) compared t...(choose a part on the right to read more)
$5,197.50
Make a selection BBI9918170001 If you have the optional sport bucket seats and planning to install 6-point race harnesses, then you will need this bracket. Without any modifications, this bracket bolts directly to the seat and keeps the harnesses at the proper 10-20° angle regardless of the seat position.
$250.00
Make a selection BBI9912020006 The bbi autosport Porsche 991 GT3 exhaust center section is a direct replacement for the secondary center muffler. For those who desire a slightly milder exhaust tune, this piece is a great alternative to our cup-style side muffler bypass pipes. By retaining stock side mufflers and valves, the factory "sports button" feature is kept to conveniently switch back and forth between the aggressive "sport" mode during spirited driving sessions and the quieter, more civil "non-sport" mode for minimal noise on the highway.
$2,100.00
Make a selection BBI9912020001 The bbi autosport Porsche 991 GT3 exhaust center section is a direct replacement for the secondary center muffler. For those who desire a slightly milder exhaust tune, this piece is a great alternative to our cup-style side muffler bypass pipes. By retaining stock side mufflers and valves, the factory "sports button" feature is kept to conveniently switch back and forth between the aggressive "sport" mode during spirited driving sessions and the quieter, more civil "non-sport" mode for minimal noise on the highway.
$2,100.00
Make a selection FVD95761890MG Factory: engine - v8 twin-turbo capacity - 4806ccm compression ratio - 10,5:1 max. Power - 368kw (500hp) @ 6000rpm max. Torque - 700nm (516 lbf ft) @ 2250-4500rpm max. Speed - 275km/h max. Rpm - 6500rpm acceleration 0-100km/h - 5.1s tuning:* max. Power - 397kw (540hp) @ 6000rpm max. Torque - 780nm (575 lbf ft) @ 3500rpm max. Speed - 280km/h max. Rpm - 6700rpm acceleration 0-100km/h - 5.0s * only with sport exhaust system and sport air filter for 27 + years, FVD-Brombacherhas been setting the standard for Porsche engine building and tuning in Germany. Our deep understanding of the flat 6 Porsche engine naturally led to our engine management software. Over the years we have perfected the art of software tuning, ...(choose a part on the right to read more)
$1,094.50
Make a selection 96536212800 Fits 1989-98 c2 and c4 and turbo. Available in 7x17, 7.5x17, 8x17, 9x17. The replica is the 7.5 and 9 sizes. Silver painted with clear coat. Originally shipped on 1991 c2 turbo and optional on the c2 and c4. View/Change Diagram
$1,321.38
Make a selection 96534703200SP We are committed to Porsche cars and are very happy to release an outer tie rod that consists of a monoball joint. Until now this was something that was really only available on racing models. Our tie rod will provide you with unequalled steering precision for street and track use. This component is manufactured in europe and contains the finest materials available, high carbon steel and 7075 t6 aluminum. Installation is seamless, this is a direct replacement for the OEM part number, 965 347 032 00. Sold individually. 2 needed per car. We also suggest replacing your inner tie rod, we have a uniball option, our part # 96434705805sp (qty. 1 is needed) and now is also a good time to replace your worn out inner tie...(choose a part on the right to read more)
$251.90
Make a selection 930602015AX3ATK Send us your distributor and we will remanufacture it for you. A perfect option for those who have time and want to save on costs. The remanufacturing process includes full inspection, disassembly, cleaning and degreasing. We then install a toothed timing belt, 3 German made top bearings, 1 German made lower bearing and a distributor pinion pin (part # 930 602 922 00). Clearances, timing and proper operation are then checked to ensure reliability. Please note: each distributor is remanufactured in Germany, so the lead times can vary.
$1,393.26
Make a selection 115971AAR01 Panamera models with optional air suspension utilize four sensors to control the ride height. This is accomplished via the use of a small linkage or link which connects the sensor to the suspension. As the car is raised or lowered, the link moves the sensor up or down sending a signal to the computer telling it how high the car is. When you replace the non-adjustable factory link with this adjustable design, the output of the sensor makes the computer believe that the car is higher than it is. So, the computer will lower the ride height. The simplicity of this setup is that it retains full functionality of the factory system. Be warned, all adjustable lowering links are not the same! These links are machined al...(choose a part on the right to read more)
$324.50
Make a selection AP958170 Agency power is proud to release its super sport exhaust system for the 958 Porsche Cayenne s v8 2011 and up. the super sport exhaust is a axle system that gives your 4.8l v8 engine a real aggressive tone. made here in the usa, the exhaust saves close to 30lbs off the rear end of the vehicle. using 304 stainless steel and detail oriented tig welding, the exhaust system uses two small high flow mufflers which give it the sports car rumble. its reduced back pressure design gives the engine improved horsepower and torque with most noticeable improvement in throttle response. because of the reduced restriction, this exhaust horsepower gains can definitely be noticed in the mid to top rpm range.
$1,495.95
Make a selection 91142470102EQ High-quality OEM replacement, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. For a complete installation, we recommend replacing the heater control cable guide tube, part # 90142470401eq and grommet, part # 91450431900 sold individually. 1 necessary per car. Please note: for models with automatic heat control (m424 option)
$16.16
Make a selection 22011090102ATK Sport throttle bodies are a great addition for those with highly modified cars. They are a great addition for those with full exhaust systems (larger diameters), maf kits, larger displacements, street or race cams, etc. The remanufacturing process includes full inspection of your throttle body to ensure proper operation after the remanufacturing process. We then disassemble and bore the original to a 2.7-inch (70.5 mm) diameter. The entire throttle body is cleaned, degreased and the internals are polished to create more laminar flow. We then machine the shaft to accept larger butterfly's which seamlessly match the bore. All clearances are checked for precision to ensure reliability. Each throttle body is reman...(choose a part on the right to read more)
$589.60
Make a selection 93011025609R01 Rubber cap for the intake distributor on the m339 all-wheel drive option cars. Sold individually. 1 necessary per car. Like new
$15.40
Make a selection HEI911002001S1 We deliver with dmsb-ons certificat ,incl. Tunneling supporting and diagonal bars for the work location motorsport you need this options: 600001 side rotection 600035 dash board panel faces optional : 600036 harness mounting tube only in steel 600006 upholstery 600014 diagonals bars with connecting joint every heigo bar or cage is considered a motorsports part and is a special-order item. Motorsports parts may have some cosmetic inconsistency's (light scratches, etc.). For a perfect show car look, we suggest ordering the bar painted or powder coated.
$2,406.80
Make a selection 100555100SC3 Since 1984, we have established an extensive network of interior specialty vendors that have stockpiled historically correct materials and have the skills necessary to reproduce to o.e. Specifications. Each carpet set is produced in Germany and includes every concours quality detail. Features: genuine German sliverknit velour - wool carpet thick / plush historically correct drivers side includes original script in gold original fitment jute/rubber backing for floor carpets heel padding vinyl bound edges for floor carpets all necessary cut outs and buttons manufactured in Germany sold as a complete set. 1 necessary per car. Please note: when ordering, please indicate the year, model, transmission, with/without f...(choose a part on the right to read more)
$1,410.20
Make a selection HEI911002001S2 We deliver with dmsb-ons certificate with wel-in parts, harness bar, tunneling supporting & diagonal bar optional : 600006 upholstery every heigo bar or cage is considered a motorsports part and is a special-order item. Motorsports parts may have some cosmetic inconsistency's (light scratches, etc.). For a perfect show car look, we suggest ordering the bar painted or powder coated.
$2,479.40
Make a selection HEI911002006A1 We deliver with dmsb-ons certificate. Includes tunneling supporting and diagonal bars optional : 600006 upholstery
$2,274.80
Make a selection 10055511089VBL Since 1984, we have established an extensive network of interior specialty vendors that have stockpiled historically correct materials and have the skills necessary to reproduce to o.e. Specifications. Each carpet set is produced in Germany and includes every concours quality detail. Features: genuine German sliverknit velour - wool carpet thick / plush historically correct drivers side includes original script in gold original fitment jute/rubber backing for floor carpets heel padding vinyl bound edges for floor carpets all necessary cut outs and buttons manufactured in Germany sold as a complete set. 1 necessary per car. Please note: when ordering, please indicate the year, model, transmission, with/without f...(choose a part on the right to read more)
$705.10
Make a selection FVD99661831MG Genuine: engine - 6 cylinder boxer capacity - 3600ccm compression ratio - 11,7:1 max. Power - 265kw (360hp) @ 7200rpm max. Torque - 370nm (273lbf ft) @ 5000rpm max. Speed - 302km/h max. Rpm - 7600rpm acceleration 0-100km/h - 4.8s tuning: max. Power - 276kw (375hp) @ 7000rpm max. Torque - 390nm (288lbf ft) @ 5000rpm max. Speed - 310km/h max. Rpm - 7900rpm acceleration 0-100km/h - 4.6s for 27 + years, FVD-Brombacherhas been setting the standard for Porsche engine building and tuning in Germany. Our deep understanding of the flat 6 Porsche engine naturally led to our engine management software. Over the years we have perfected the art of software tuning, making substantial gains in horsepower and torque, while re...(choose a part on the right to read more)
$1,204.50
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |